FORD 9-Inch Rear End Housing, Axles, Chromoly Torque Arm & Center Section

The Trick Chassis FORD 9-Inch Rear End Axle Package for 1993–2002 Camaro & Firebird includes the housing, axles, chromoly torque arm and center section. It’s a full setup built for serious drag racing & track use — no upcharges for parts that should come standard.

Below is what is included in the package for the base price:

• Brand new center fabricated housing can (STANDARD) Others charge $100 more
• Internal axle tube gussets (STANDARD) Others charge $75 more
• 3″ .250 wall DOM axle tubes (STANDARD)
• 11 lower control arm mounting holes (STANDARD)
• 28, 31, 35 spline axle options (YOUR CHOICE)
• Drive studs included 12mm, 1/2-2″,1/2-3″ (YOUR CHOICE)
• Housing vent included
• Wheel bearings included
• 10 nuts to bolt the center section in
• Yukon center section with a spool in it (your choice of gear)
• Shipped bare steel
• We can narrow for free (see options)

Options for additional charge:

• T bolt brake hardware kit (easy install of your stock F Body backing plates)
• Lube Locker Gasket (Super nice aluminum core gasket with orange elastomer beading)
• 40 spline upgraded axles (gun drilled)
• 5/8″ wheel studs
• Powder coat
• Fill & drain caps
• Sway bar brackets (these also allow you to bolt our under-axle roll bar on)
• Coil over brackets
• Coil over brackets with no spring perches added
• Differential being used (instead of spool)

Please call or email us for pricing & estimated time:

• We offer full bolt in assemblies
• Wishbone application
• Only torque arm & no other bracket setups
• Extreme custom applications (we have done many of these)
• Crate & freight available
• International shipping* Our website will not calculate duties/taxes/shipping/broker setups

Important information:

Axles & center section are dropped shipped and may show up at an earlier or later time than the housing

With the 11-hole lower brackets they are narrower to allow more tire clearance for guys running a wider tire. You will need to purchase a double rod end lower. We can supply you with a set for $149.99.

Proper Bearing & Backing Plate Assembly for Trick Chassis ’98-’02 F Body 9″ Rear End Axle with LS1 Backing Plates

This is a common question, so here’s a step-by-step guide to get it right the first time:

Critical Bearing Installation Steps:

1. Install Wheel Studs First – Use Loctite & torque them properly before moving on
2. Position the Backing Plates – Slide them onto the correct axle:
   • Long axle = Passenger side
   • Short axle = Driver side
3. Press the Bearings On – Make sure the O-ring is closest to the axle flange (see pic 1)
4. Press on the Lock Rings – Do this only after the bearings are fully seated against the bearing spacer
5. Install the Seals – Use a seal installer to press them into the housing ends (see pic 2)

Getting these steps right ensures a proper fit and long-lasting performance. 🔧